The Dual VCO is a 4hp Dual Voltage Controlled Analog Oscillator Eurorack Module available as a DIY Eurorack Kit or Built.
Each VCO has square, triangle, and sine wave out, coarse and fine tuning controls, a control voltage input, and a switch for selecting exponential or linear cv in. When a control voltage is inserted, the fine tune control becomes an attenuator for the incoming voltage. In exponential mode, when the attenuator is fully clockwise, the VCO will track around 5 volts per octave.
the dual vco currently ships with the black/white pcb panel(if you want one assembled with an aluminum panel, add the additional panel to your cart)
FOR DIY KITS AND PCB/PANELS: ALL 3 SMD COMPONENTS COME PRE-SOLDERED
- Width: 4hp
- Panel Material: PCB or aluminum
- Range: 0.2 hz (5 seconds a cycle) up to 18k hz
- Temperature compensated
- Waveform outputs 10vpp
- Reverse Power Protected
- Current Consumption: +12v 20mA, -12v 40mA
- Depth: 45mm
- Ships with M3 black nylon screws
- Build Difficulty: Advanced
- Expandable: no
There are a couple quirks to these 8038 VCOs
Below 300 hz the waveform symmetry is slightly off. triangle waves get a little uneven in the lfo range, the sine is not completely perfect to begin with the bottom trough and in the lfo range it slopes slightly, and the square turns more trapezoidal above 1khz(see scope shots) Also it doesn’t track 1 volt per octave perfectly. usually the 1st and 3rd octave will be a couple cents off. Other than those idiosyncrasies, it is a powerful, stable dual oscillator in a small footprint with no cross talk between oscillators. It’s great for: drones and beating sine or triangle
waves, cross modulating itself for interesting clocks/LFOs, creating complex waveforms/timbres through lin/exp frequency modulation.
Condition: New
Info from Zlob